LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mercury >> 2005 >> Montego Base, FWD >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Electronic Engine Control System >> Removal And Installation >> Powertrain Control Module (PCM) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Powertrain Control Module (PCM): Installation

  1. Install the PCM and the bolt.
    • Tighten to 8 Nm (71 lb-in).
  2. Connect the 3 PCM electrical connectors.
  3. Install the cowl panel grille. For additional information, refer to FRONT END BODY PANELS .
  4. Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  5. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation procedure. For additional information, refer to MODULE CONFIGURATION .
  6. Reprogram the passive anti-theft system (PATS). Carry out the Key Programming Using Two Programmed Keys procedure. For additional information, refer to ANTI-THEFT - PATS .
  7. Carry out the Transaxle Drive Cycle Test. For additional information, refer to AUTOMATIC TRANSAXLE - 6 SPEED .
scientia non olet · About LEMON Manuals