Instrument Cluster (Ic), Message Center, And Warning Chimes DTCS
INSTRUMENT CLUSTER (IC) DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Perform Test |
|---|---|---|
| B1202 | Fuel Sender Circuit Open (fuel pump module sender) | For front wheel drive (FWD) sedan, go to Pinpoint Test B
. For wagon or all wheel drive (AWD) sedan, go to Pinpoint Test C . |
| B1204 | Fuel Sender Circuit Short to Ground (fuel pump module sender) | For front wheel drive (FWD) sedan, go to Pinpoint Test B
. For wagon or all wheel drive (AWD) sedan, go to Pinpoint Test C . |
| B1205 | EIC Switch-1 Assembly Circuit Failure | Go to Pinpoint Test AL . |
| B1318 | Battery Voltage Low | Go to Pinpoint Test AB . |
| B1342 | ECU is Faulted | REPAIR all other DTCs first. CLEAR the DTCs. REPEAT the self-test. If DTC B1342 is retrieved again, INSTALL a new instrument cluster (IC). REFER to Instrument Cluster (IC) . TEST the system for normal operation. |
| B1482 | Wiper Washer Fluid Level Sensor Circuit Short To Ground | Go to Pinpoint Test AO . |
| B1868 | Lamp Air Bag Warning Indicator Circuit Failure | VERIFY that DTCs are present in the restraints control module (RCM). If DTCs are present, INSTALL a new instrument cluster (IC). REFER to Instrument Cluster (IC) . TEST the system for normal operation. If DTCs are not present and the air bag warning indicator is not on, the system is operating normally. |
| B2097 | Compass Module Failure | Go to Pinpoint Test AM . |
| B2143 | NVM Memory Failure | Go to Pinpoint Test H . |
| B2477 | Module Configuration Failure | REFER to MODULE CONFIGURATION article. |
| B2627 | Fuel Sender Circuit Open #2 (secondary fuel sender) | Go to Pinpoint Test C . |
| B2628 | Fuel Sender Circuit Short To Ground #2 (secondary fuel sender) | Go to Pinpoint Test C . |
| B2879 | Fuel Tank Jet Pump Fault | Go to Pinpoint Test C . |
| B2A20 | Ignition Stuck in Start | Go to Pinpoint Test AC . |
| C1093 | Traction Control Disable Switch Circuit Failure | REFER to VEHICLE DYNAMIC SYSTEMS article. |
| U0073 | Control Module Communication Bus A Off | REFER to MODULE COMMUNICATIONS NETWORK article. |
| U0074 | Control Module Communication Bus B Off | REFER to MODULE COMMUNICATIONS NETWORK article. |
| U0100 | Lost Communication With ECM/PCM | Go to Pinpoint Test AD . |
| U0114 | Lost Communication With Four-Wheel Drive Clutch Control Module | Go to Pinpoint Test AE . |
| U0121 | Lost Communication With Anti-Lock Brake System (ABS) Control Module | Go to Pinpoint Test AF . |
| U0140 | Lost Communication With Body Control Module (GEM) | Go to Pinpoint Test AG . |
| U0151 | Lost Communication With Restraints Control Module (RCM) | Go to Pinpoint Test AH . |
| U0164 | Lost Communication With HVAC Control Module (EATC) | Go to Pinpoint Test AI . |
| U0208 | Lost Communication With Seat Control Module (DSM) | Go to Pinpoint Test AJ . |
| U0230 | Lost Communication With Rear Gate Module (LTM) | Go to Pinpoint Test AK . |
| U2013 | Compass Module Is Not Responding | Go to Pinpoint Test AM . |
| U2023 | Fault Received From External Node | U2023 is set when a module receives invalid network data from another module with a faulted input. RETRIEVE and REPAIR all non-network DTCs in the other modules on the network. REFER to MULTIFUNCTION ELECTRONIC MODULES article for a list of all DTCs. |
| U2050 | No Application Present | CARRY OUT the instrument cluster (IC) programmable module installation (PMI). REFER to MODULE CONFIGURATION
article. If the DTC reappears, INSTALL a new instrument cluster (IC). REFER to Instrument Cluster (IC) . TEST the system for normal operation. |
| U2196 | Invalid Engine RPM Data | U2196 is set when the instrument cluster (IC) module receives invalid network data from the PCM with a faulted input. RETRIEVE and REPAIR all non-network DTCs in the other modules on the network. REFER to MULTIFUNCTION ELECTRONIC MODULES article for a list of all DTCs. |
| U2199 | Invalid Engine Coolant Temperature Data | U2199 is set when the instrument cluster (IC) module receives invalid network data from the PCM with a faulted input. RETRIEVE and REPAIR all non-network DTCs in the other modules on the network. REFER to MULTIFUNCTION ELECTRONIC MODULES article for a list of all DTCs. |
| U2472 | Unexpected Ignition State | Go to Pinpoint Test AC . |
| U261A | CAN Data/Configuration Setup Mismatch | The instrument cluster (IC) and smart junction box configuration do not match. If either an instrument cluster (IC) or SJB was installed, CARRY OUT the programmable module installation (PMI) for the suspect module. REFER to MODULE CONFIGURATION article. CLEAR the DTCs. REPEAT the self-test. |
| All other DTCs | - | REFER to MULTIFUNCTION ELECTRONIC MODULES article. |
SMART JUNCTION BOX (SJB) DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Perform Test |
|---|---|---|
| B1352 | Ignition Key-In Circuit Failure | If the chime sounds with the door ajar and no key in the ignition, go to Pinpoint Test AQ
. If the key-in-ignition chime is inoperative, go to Pinpoint Test AR . |
| B2479 | Brake Park Switch Circuit Short to Ground | Go to Pinpoint Test O . |
| C1125 | Brake Fluid Level Sensor Input Circuit Failure | Go to Pinpoint Test O . |
| All other DTCs | - | REFER to MULTIFUNCTION ELECTRONIC MODULES article. |
PCM DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Perform Test |
|---|---|---|
| P0457 | Evaporative Emission System Leak Detected (fuel cap loose/off) | Go to Pinpoint Test Y . |
| P0460 | Fuel Level Sensor A Circuit | REFER to the Introduction - Gasoline Engines
article first. If sent here from the Powertrain Control/Emissions Diagnosis (PC/ED) manual, go to Pinpoint Test B for front wheel drive (FWD) sedan. If sent here from the PC/ED manual, go to Pinpoint Test C for wagon or all wheel drive (AWD) sedan. |
| P0461 | Fuel Level Sensor A Circuit Range/Performance | REFER to the Introduction - Gasoline Engines
article first. If sent here from the PC/ED manual, go to Pinpoint Test B for front wheel drive (FWD) sedan. If sent here from the PC/ED manual, go to Pinpoint Test C for wagon or all wheel drive (AWD) sedan. |
| P0462 | Fuel Level Sensor A Circuit Low | REFER to the Introduction - Gasoline Engines
article first. If sent here from the PC/ED manual, go to Pinpoint Test B for front wheel drive (FWD) sedan. If sent here from the PC/ED manual, go to Pinpoint Test C for wagon or all wheel drive (AWD) sedan. |
| P0463 | Fuel Level Sensor A Circuit High | REFER to the Introduction - Gasoline Engines
article first. If sent here from the PC/ED manual, go to Pinpoint Test B for front wheel drive (FWD) sedan. If sent here from the PC/ED manual, go to Pinpoint Test C for wagon or all wheel drive (AWD) sedan. |
| P2065 | Fuel Level Sensor B Circuit | REFER to the Introduction - Gasoline Engines
article first. If sent here from the PC/ED manual, go to Pinpoint Test C . |
| P2066 | Fuel Level Sensor B Circuit Range/Performance | REFER to the Introduction - Gasoline Engines
article first. If sent here from the PC/ED manual, go to Pinpoint Test C . |
| P2067 | Fuel Level Sensor B Circuit Low | REFER to the Introduction - Gasoline Engines
article first. If sent here from the PC/ED manual, go to Pinpoint Test C . |
| P2068 | Fuel Level Sensor B Circuit High | REFER to the Introduction - Gasoline Engines
article first. If sent here from the PC/ED manual, go to Pinpoint Test C . |
| All other DTCs | - | REFER to the Introduction - Gasoline Engines article. |