Removal And Installation

CAUTION: Do not allow the clockspring to rotate while the steering wheel is disconnected or damage to the clockspring may result. If there is evidence that the clockspring has rotated, the clockspring must be recentered. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM article.

Place the steering wheel in the straight-ahead position and remove the ignition key.
Remove the driver air bag module. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM article.
Remove and discard the steering wheel bolt.
- To install, tighten to 47 Nm (35 lb-ft).
Remove the steering wheel.
- Disconnect the steering wheel switches electrical connector from the clockspring.
- Route the 2 driver air bag module electrical connectors and harness through the steering wheel.

Fig 1: Identifying Connectors

Courtesy of FORD MOTOR CO.

To install, reverse the removal procedure.
- Install the driver air bag module. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM article.