Fuel Injection And Induction System Cleaning (M04 07 07)

Publication date: 2007-12-17
Reference number: M04 07 07

FUEL INJECTION AND INDUCTION SYSTEM CLEANING

TECHNICAL SERVICE BULLETIN

Reference Number(s): SI M04 07 07, Date of Issue: December 17, 2007

MINI:	R50 (Cooper) vehicles equipped with W10 engine; R52 (Cooper and Cooper S) vehicles equipped with W10 and W11 engines; R53 (Cooper S) vehicles equipped with W11 engine; R56 (Cooper) vehicle equipped with N12 engine
GROUP:	Tools and Equipment

Superceded Bulletin(s): SI M04 07 07, Date of Issue: April 2007

NOTE: This Service Information bulletin supersedes SI M 04 07 07 dated April 2007.

SUBJECT

Fuel Injection and Induction System Cleaning

SITUATION

Deposits found in the injection and induction system will cause the vehicle to experience a variety of driveability complaints, eventually leading to the illumination of the Service Engine Soon Lamp. Refer to SI M13 01 07 for complete details, as well as in-depth operational instructions.

Distribution of the following tools will be through the Automatic Tool Shipment Program. Additional tools may be purchased through your PDC.

Fuel Injector and Induction System Cleaner Applicator Kit

PN 82 14 0 429 692

Chain with hook
Shop air connection
Regulator
Cylinder
Gauge
Pressure relief button
Quick connect
Pressure relief hose with rubber plug

Fig 1: Fuel Injector And Induction System Cleaner Applicator Kit

Fuel Injector and Induction System Cleaner Concentrate

PN 82 14 0 428 376

The cleaner will not be sent via the Automatic Tool Shipment Program. This item must be ordered by each center.

Fig 2: Fuel Injector And Induction System Cleaner Concentrate

IMPORTANT: Before starting the cleaning procedure, place the vehicle in a well-ventilated area. If the cleaning procedure occurs indoors, be sure to have the vehicle connected to an exhaust removal system. It is necessary to wear Nitrile rubber gloves and safety glasses during this procedure.

TOOL WARRANTY INFORMATION

The use of non-approved materials voids the warranty of the Fuel Injector and Induction System Cleaner Applicator Kit PN 82 14 0 429 692 and its contents. All of these tools are returned for inspection. If the materials causing damage to these tools have been identified, then the tool will be returned to your center and a replacement credit will not be applied. When the tools described above are returned for warranty reimbursement, the tool must be accompanied by contact information and a reason for return in the shipping carton. Using a non-approved material can lead to deterioration of the tool, resulting in incorrect operation and a possible safety concern.

The Fuel Injector and Induction System Cleaner Applicator is constructed with materials that are compatible with gasoline and the Fuel Injector and Induction System Cleaner Concentrate PN 82 14 0 428 376 only .