Manual Input of ZCS Data (w/ Progman v. 14 & 15): Notes
From Progman establish a connection to the interface connected to the vehicle and access CIP.
To perform the procedure from CIP the Model series must be selected.
Then select the body.
Select Codierung ZCS/FA .
Then advance screen to the right two times to enter the vehicle series selection screen.
The version ID page is displayed.
Make sure it is the most up-to-date version of the software for the encoding procedure.
Press the right arrow.
Select vehicle series (i.e "E36 Series").
Select Recoding .
Then advance screen to the right.
Displays control modules that are ZCS codable.
Select KOMBI .
Select Yes to recode KOMBI.
Follow the instructions given on screen.
Chassis number of vehicle is displayed.
Select "Yes" to accept VIN.
Select "No" if VIN needs to be changed.
When installing a new module the last 7 digits of the VIN will need to be entered.
Follow the instructions given on screen.
Chassis number of vehicle is displayed, enter VIN using touch screen pad or the keyboard on an SSS.
Select "Yes" to accept VIN.
Select "No" if VIN needs to be changed/corrected.
When installing a new module the last 7 digits of the VIN will need to be entered.
Current ZCS code is displayed.
Select "Yes" to accept current code.
Select "No to change the ZCS data.
When installing a new module the ZCS code of the vehicle will need to be entered. The information can be obtained from:
- ZCS print out of old module before removal.
- ZCS label located in vehicle.
If the ZCS code must be changed follow the instruction given on screen and enter the required information exactly as indicated on the ZCS label or printout of ZCS code before removal of module.
Confirm or enter new GM information.
Confirm or enter new SA information.
By selecting "EWS adjustm." or "CAS Calibration" the rolling code tables can be initialized.
By selecting "Yes" the calibration/initialization of the rolling code tables in the DME and CAS or EWS modules will be carried out.