Section 1011 (Coding And Programming - Overview): Progman: Administration: Settings: Network
WARNING: This page does not describe the selected car, but rather 333 other vehicles, including the 2007 BMW Z4, 2007 BMW X5, 2007 BMW X3, 2007 BMW M6, and 2007 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
The Network function allows network configuration information specific to the SSS to be entered, these settings should have been set during the initial installation of Progman/CIP15.0.
NOTE:
Maintain a copy of the system configuration information, in the event information gets disturbed, printout a copy and keep in a binder along with information for DISplus, GT1 and the interfaces.
Information that can be entered is similar to the information needed to configure an interface. The following information must be entered to correctly configure the SSS to the network:
- Assign a name specific to the SSS
- Gateway Address
- IP Address specific to SSS
- Information pertaining to the IP subnet mask
Any changes that are made to the configuration are saved by selecting continue and will go into effect once the SSS is restarted.
NOTE:
Restart immediately means that Progman checks the current status of any sessions that are still active and once the sessions are complete the system will restart.
Restart later indicates that Progman will wait until the end of the day (specified under "Operating Times") to check and restart the system.