Section 2504 (Integrated Suspension Systems - Repair)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
- General
- 00 Safety information for working on vehicles with automatic engine start-stop function (MSA)
- 00 Danger of poisoning if oil is ingested/absorbed through the skin
- 00 Risk of injury if oil comes into contact with eyes and skin
- 00 Safety instructions for handling oil
- 00...... Raising vehicle with trolley jack
- 37...... Overview of Dynamic Drive (ARS)
- 37...... Overview of Vertical Dynamics Management (VDM)
- 37...... Overview of ride-height control system
- 37..... Performing vertical acceleration sensor adjustment (vertical dynamics management)
- 37 00... Notes on air spring system
- 37 00... Checking air springs for damage
- 37 00... Inspection sheet
- 37 00 100 Draining/filling air spring system
- 37 10 001 Initial operation with test run of Dynamic Drive
- Front Control And Suspension
- Rear Control And Suspension
- 37 00... Checking air springs for damage
- 37 12... Replacing lower vent line for air supply unit
- 37 12... Replacing pipes for air springs
- 37 12... Replacing upper vent line for air supply unit
- 37 12 001 Checking function of ride-height control system
- 37 12 012 Carrying out ride-height adjustment
- 37 12 155 Removing and installing/replacing left or right air spring
- 37 12 220 Removing and installing/replacing rear active stabilizer
- Connecting Lines
- 37 13... Notes on fitting a new pipe or a screw connection
- 37 13... Removing and installing/replacing pressure line (middle) for oscillating motor/rear axle
- 37 13... Removing and installing/replacing pressure lines (front) for oscillating motor/front axle
- 37 13... Removing and installing/replacing pressure lines (front) for oscillating motor/rear axle
- 37 13... Removing and installing/replacing pressure lines (rear) for oscillating motor/front axle
- 37 13... Removing and installing/replacing pressure lines (rear) for oscillating motor/rear axle
- 37 13 100 Removing and installing/replacing pressure lines for oscillating motor/front axle
- 37 13 110 Removing and installing/replacing pressure lines for oscillating motor/rear axle
- Electrical Components
- 37 14 055 Removing and installing/replacing DYNAMIC DRIVE control unit
- 37 14 511 Replacing front right ride-height sensor
- 37 14 515 Replacing rear left or right ride-height sensor
- 37 14 521 Replacing front left ride-height sensor
- 37 14 525 Removing and installing/replacing control unit for air supply unit
- 37 14 610 Removing and installing/replacing transversal-acceleration sensor
- Electronic Damping
- Pump Assembly With Condenser
- Troubleshooting