Section 3701 (Integrated Suspension Systems - Repair)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.
- General
- 37 00... Checking air springs for damage
- 00 Danger of poisoning if oil is ingested/absorbed through the skin
- 37 10 001 Initial operation with test run of Dynamic Drive
- 37 00... Notes on air spring system
- 37... Overview of 2-axle ride-height control
- 37.... Overview of Dynamic Drive (ARS)
- 37.... Overview of Vertical Dynamics Management (VDM)
- 37...... Overview of ride-height control system
- 37..... Performing vertical acceleration sensor adjustment (vertical dynamics management)
- 00 Risk of injury if oil comes into contact with eyes and skin
- 00 Safety information for working on vehicles with automatic engine start-stop function (MSA)
- 00 Safety instructions for handling oil
- 37 10 001 Start-up with test run of Dynamic Drive (EPS steering gear)
- Front Control And Suspension Elements
- 37 11 030 Removing and installing front left or right spring strut
- 37 11 010 Removing and installing/replacing front active anti-roll bar
- 31 33 100 Replacing front left or right coil spring
- 37 11 032 Replacing front left or right spring strut shock absorber
- 37 11 020 Replacing pressure relief valves for active anti-roll bar at front
- Rear Control And Suspension Elements
- Connecting Lines
- 37 13... Notes on fitting a new pipe or a screw connection
- 37 13... Overview of Dynamic Drive (ARS) pressure lines, front axle
- 37 13... Overview of Dynamic Drive (ARS) pressure lines, rear axle
- 37 13... Overview of lines, steering with ARS
- 37 13 120 Removing and installing/renewing pressure line for VA1 swivel motor
- 37 13 127 Removing and installing/renewing pressure lines for valve block (short)
- 37 13 121 Removing and installing/replacing pressure line for valve block VA1
- 37 13 132 Removing and installing/replacing pressure lines for oscillating motor (HA1/HA2)
- 37 13 130 Removing and installing/replacing underfloor pressure lines for oscillating motor (HA1/HA2)
- 37 13 125 Removing and refitting/replacing pressure line on swivel motor VA2
- 37 13... Replacing return line (short)
- Electrical Components
- 37 10 001 Initial operation with test run of Dynamic Drive
- 37 14 055 Removing and installing/replacing Vertical Dynamics Management control unit (VDM with Dynamic Drive)
- 37 14 525 Removing and installing/replacing control unit for air supply system
- 37 14 515 Replacing front left or right ride-height sensor
- 37 14 515 Replacing rear left or right ride height sensor
- 37 10 001 Start-up with test run of Dynamic Drive (EPS steering gear)
- Electronic Damping Force Adjustment
- Pump Assembly With Container