Abs/DSC Control During Light Braking (M34 01 12)

Publication date: 2013-01-01
Reference number: M34 01 12

ABS/DSC CONTROL DURING LIGHT BRAKING

TECHNICAL SERVICE BULLETIN

Reference Number(s): SI M34 01 12, Date of Issue: January 2013

MINI:	R55; R56; R57; R58; R59; R60; Produced from 8/2010 through 10/2012
GROUP:	Brakes

SUBJECT

ABS/DSC Control During Light Braking

SITUATION

When driving slowly over uneven road surfaces, there may sometimes be pre-mature ABS application relative to the driving situation with the brake lightly applied.

CAUSE

Software in the Dynamic Stability Control unit (DSC)

CORRECTION

Run diagnostics with ISTA/D and work through any corresponding test modules, then program and code the vehicle with ISTA/P 2.48.0 or higher.

Do not replace parts.

Note that ISTA/P will automatically reprogram and code all programmable control modules that do not have the latest software.

For information on programming and coding with ISTA/P, refer to CenterNet / Aftersales Portal / Service / Workshop Technology / Vehicle Programming.

NOTE: When the ISTA system message displays: Battery voltage only "XX.XX" V. Please connect charger. Please note the displayed battery voltage reading in the repair order comments section. This documentation is not necessary when part of an approved Technical Service repair procedure; the battery charger is required to be attached before performing the Vehicle Test.

WARRANTY INFORMATION

Covered under the terms of the MINI Passenger Car Limited Warranty or the MINI NEXT Certified Pre-Owned Limited Warranty.

WARRANTY INFORMATION

Defect Code:	34 52 10 15 00
Labor Operation:	Labor Allowance:	Description:
00 00 006	Refer to KSD2	Performing "vehicle test" (with vehicle diagnosis system - checking faults)
and if necessary, also
61 21 528	Refer to KSD2	Charging battery
and
61 00 710	Refer to KSD2	Programming / encoding control unit(s) (not including CAS)
or
61 00 720	Refer to KSD2	Programming / encoding control unit(s) (with CAS)

Labor operation code 00 00 006 is a Main labor operation. If you are using a main labor code for another repair, use the plus code labor operation 00 00 556 instead.

Refer to KSD2 for the corresponding flat rate unit (FRU) allowance. Enter the Chassis Number, which consists of the last 7 digits of the Vehicle Identification Number (VIN). Click on the "Search" button, and then enter the applicable flat rate labor operation in the FR code field.

If a control module fails to program correctly or initializations are required, the additional work must be claimed with separate labor operations under the defect code listed above; refer to KSD2.

Other Repairs

If performing other ISTA diagnostics and the related test plans results with eligible and covered work, claim this work with the applicable defect code and labor operations listed in KSD2.

NOTE: Please follow any TeileClearing (TC) or Diagcode (DC) requirements that may apply to this additional work.