Section 2504 (Front Axle - Repair)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
- General
- 00 Danger of poisoning if oil is ingested/absorbed through the skin
- 00 Risk of injury if oil comes into contact with eyes and skin
- 00 Safety instructions for handling oil
- 00...... Raising vehicle with trolley jack
- 31... Front axle overview
- 31.... Layout of spring strut shock absorber
- 31.... Overview of front differential/output shafts
- 31 00... Front axle + steering: wheel/chassis alignment check must be carried out after the following work
- 31 00... Information on replacing shock absorbers
- 31 00... Instructions (chassis components made of aluminum)
- 31 00... Notes on repairing threads
- 23 0 020 Holder
- 00 Safety information for working on vehicles with automatic engine start-stop function (MSA)
- Front Axle Suspension
- Front Sub-Frame
- Struts W/Rubber Mounts
- 31 12 002 Removing and installing/replacing top left control arm
- 31 12 003 Removing and installing/replacing top right control arm
- 31 12 003 Removing and installing / replacing top right wishbone
- 31 12 004 Removing and installing/replacing left or right lower control arm
- 31 12 007 Replacing rubber mounts for front axle carrier in both lower control arms
- 31 12 008 Replacing rubber mounts for spring strut holder in both lower control arms
- 31 12 043 Removing and installing/replacing complete front left or right spring strut holder
- 31 12 050 Removing and installing/replacing left or right tension strut
- 31 12 134 Replacing rubber mounts on both tension struts/trailing links
- Wheel Bearing And Stub Axle
- Spring Strut
- Spring With Suspension
- Stabilizer Bar
- Front Axle Gearbox
- Differential With Bearings
- 31 51 010 Replacing radial seal for drive flange of front differential
- 31 51 015 Replacing shaft seal for left output shaft
- 31 51 020 Replacing shaft seal for right output shaft
- 31 51 060 Replacing O-ring for front differential on right
- 31 51 065 Replacing O-ring for bearing block
- 31 53 040 Removing and installing/replacing right output shaft bearing block
- Output Shaft
- 31 60... Notes on removing and installing Low Profile band clamps
- 31 60... Securing right output shaft with special tool 31 4 180
- 31 60... Pressing output shaft out of drive flange (wheel hub) and drawing in
- 31 60 003 Removing and installing or replacing left output shaft
- 31 60 004 Removing and installing/replacing right output shaft
- 31 60 530 Replacing an output shaft gaiter (on transmission side) (output shaft removed)
- 31 60 535 Replacing two gaiters on output shaft(s) (output shaft(s) removed)
- Troubleshooting