LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 1986 >> Starion ESI-R >> Repair and Diagnosis >> Engine Performance >> Ignition System - Electronic >> Testing >> ESC IGNITOR Test >> Turbo Models
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Turbo Models

  1. Warm engine to normal operating temperature. Connect a timing light and set to specification. Check centrifugal spark advance and repair if necessary. Set engine to 1000 RPM.
  2. Using a hammer, lightly tap injector mixer mounting stud. Check to see if spark retards. If not, go to next step. If so, measure voltage between ignitor terminal number 6 and ground. If there is one volt or less, repair or replace pressure sensor and/or shorted wiring harness. If more than one volt is present, replace defective ESC ignitor.
  3. Disconnect pressure sensor connector. Check to see if spark timing retards. If not, go to next step. If spark retards, check detonation shielding wire for continuity. If okay, detonation sensor or ESC ignitor is defective. If not, repair or replace shielding harness.
  4. Using a hammer, lightly tap injector mixer mounting stud. Check to see if spark timing retards. If not, replace ESC ignitor or detonation sensor. If spark retards, disconnect detonation sensor connector.
  5. Check for spark timing retarding 8 degrees. If not, ESC ignitor is defective. If so, ESC ignitor is okay. Reconnect wiring.
scientia non olet · About LEMON Manuals