LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 1986 >> Starion ESI-R >> Repair and Diagnosis >> Engine Performance >> System >> Fuel Injection System - MITSUBISHI >> Testing >> Injector Coil >> ISC Servo
April 5, 2026: LEMON Manuals is launched! Read the announcement.

ISC Servo

  1. Connect voltmeter between terminal No. 3 and injection mixer body. Do not disconnect ISC servo connector. Turn ignition switch from the "OFF" position to the "ON" position. While keeping ignition on for at least 15 seconds, check voltmeter reading.
  2. With ignition switch on, voltmeter should read 11-13 volts. After momentary indication of one volt, needle should stabilize at 6-13 volts. This indicates ISC servo and position switch are operating normally. Turn ignition switch to "OFF" to remove voltmeter.
scientia non olet · About LEMON Manuals