LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 1990 >> Eclipse Base, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests - PFI >> Ignition System >> TDC Sensor (DOHC Engines) >> Test No. 3
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test No. 3

  1. Disconnect crank angle connector. Turn ignition on. Connect voltmeter negative lead to ground.
  2. On Eclipse 2.0L (VIN R and U) and Galant 2.0L (VIN R), connect voltmeter positive lead to crank angle connector terminal No. 4. On Mirage 1.6L, connect voltmeter positive lead to crank angle connector terminal No. 3.
  3. On all models, if voltmeter reads 5 volts, replace crank angle and TDC sensor assembly. If voltmeter reads 0 volts, turn ignition off. Disconnect 24-pin connector from Engine Control Unit (ECU). Connect one lead of ohmmeter to ground.
  4. At main harness side of crank angle connector, connect other ohmmeter lead to crank angle connector terminal No. 4 (Eclipse 2.0L VIN R and U, and Galant 2.0L VIN R) or terminal No. 3 (Mirage 1.6L).
  5. On all models, if there is continuity, repair short to ground in ground wire between crank angle connector and ECU connector. If there is no continuity, replace ECU.
scientia non olet · About LEMON Manuals