Power Transistor (Fuel Injected Models)

Disconnect power transistor connectors. Using a DVOM, connect positive ohmmeter lead to terminal No. 2 and negative lead to terminal No. 3. See Fig 5 . Ensure there is no continuity.
Using a 1.5-volt dry cell battery, connect positive end of 1.5-volt battery to power transistor terminal No. 1 and negative end to terminal No. 2. DVOM should now read continuity at power transistor terminals No. 2 and No. 3. If DVOM does not respond as described, replace power transistor.

Fig 1: Ignition Coil Terminal Identification (Magnetic & Optical Ignition)(Eclipse, Mirage 1.5L, Pickup 2.4L & Precis)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 2: Ignition Coil Terminal Identification (Magnetic & Optical Ignition)(Galant, Montero 3.0L & Pickup 3.0L)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 3: Ignition Coil Terminal Identification (Magnetic & Optical Ignition)(Montero 2.6L)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 4: Ignition Coil Terminal Identification (Magnetic & Optical Ignition)(Van/Wagon)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 5: Testing Power Transistor (Magnetic & Optical Ignition)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.