Control Relay (1.5L & 2.4L)
- Remove control relay, located under left side of dashboard, near instrument panel. Using an ohmmeter, check continuity between relay terminals No. 1 and No. 4. See Fig 1
. Continuity should not be present. If continuity is present, control relay is defective, replace control relay. If continuity is not present, go to next step.
- Check continuity between terminals No. 3 and 8, then No. 2 and 8. Approximately 95 ohms resistance should be present. Check continuity between terminals No. 6 and 7. Approximately 35 ohms resistance should be present. Connect a 12 volt battery across relay terminals No. 6 (positive) and 7 (negative).
- Continuity should be present between terminals No. 1 and 4. Disconnect battery from relay. Using ohmmeter check between terminals No. 1 and 2. Continuity should not be present. Check between terminals No. 7 and 5, then reverse leads.
- Continuity should exist in one direction only. Connect 12 volt battery across terminals No. 5 and 7. Continuity should be present between terminals No. 1 and 2. If results are not satisfactory, replace control relay.
Courtesy of HYUNDAI MOTOR CO.