Retrieving Codes (Scan Tester)
NOTE:
If scan tester is needed to perform diagnostic test with key in START position, an auxiliary power source is needed to operate scan tester. Use optional Battery Harness (09391-33500
).
NOTE:
For specific operating procedures using scan tester, see instruction manual.
- Before entering on-board diagnostics, refer to SERVICE PRECAUTIONS . Turn ignition switch to OFF position. Locate Data Link Connector (DLC), next to fuse block. Connect power source terminal of scan tester to cigarette lighter socket. See Fig 1 .
- Connect scan tester to Data Link Connector (DLC). Turn ignition on. Read and record scan tester self-diagnostic output. Perform necessary repair(s). See TROUBLE CODES .