Fuel Trim Monitor

This monitor applies to DTCs P0170 and P0173. Following conditions must be met during the test:

• Engine coolant temperature is 176-207°F (80-97°C).
• Atmospheric temperature is 14-140°F (-10-60°C).
• Selector lever is in "D" range.

Monitor takes about 35 minutes to complete. To run monitor, use illustration. See Fig 1. Perform steps as follows:

1. Remove all test equipment from vehicle and install all components and connectors that were removed or disconnected during testing.
2. After engine is completely warmed up, turn ignition off.
3. Start engine and quickly accelerate to 55-60 MPH.
4. Drive at 55-60 MPH for 30 minutes or more. During this period DO NOT drive at constant speed for more than 120 seconds. Carry out gradual deceleration and acceleration within every 120 second time frame.
5. Return vehicle to shop and turn ignition off.

Fig 1: Running Fuel Trim Monitor

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.