Power/Heated Mirrors - Except Evolution
- Operation
- Special Tools
- Diagnosis
- Symptom Procedures
- Inspection Procedure 1: All Heated Door Mirrors Do Not Operate
- Circuit Diagram
- Circuit Operation
- Troubleshooting Hints
- Diagnosis
- Step 1: Check The Defogger
- Step 2: Check The Battery Power Supply Circuit To The Remote Controlled Mirror (RH) Test At Remote Controlled Mirror (RH) Connector E-20
- Step 3: Check The Remote Controlled Mirror (RH) Connector E-20 And Junction Block Connector C-214 For Loose, Corroded Or Damaged Terminals, Or Terminals Pushed Back In The Connector
- Step 4: Check The Wiring Harness Between The Remote Controlled Mirror (RH) Connector E-20 (Terminal No. 1) And Junction Block Connector C-214 (Terminal No. 3)
- Inspection Procedure 2: Right Or Left Heated Door Mirror Does Not Operate
- Circuit Diagram & Connector Identification
- Circuit Operation
- Troubleshooting Hints
- Diagnosis
- Step 1: Verify The Operation Of Each Heated Door Mirror
- Step 2: Check The Heated Door Mirror (LH)
- Step 3: Check The Ground Circuit To The Door Mirror (LH)
- Step 4: Check The Remote Controlled Mirror (LH) Connector E-19 For Loose, Corroded Or Damaged Terminals, Or Terminals Pushed Back In The Connector
- Step 5: Check The Wiring Harness Between The Remote Controlled Mirror (LH) Connector E-19 (Terminal 4) And Ground
- Step 6: Check The Remote Controlled Mirror (LH) Connector E-19 For Loose, Corroded Or Damaged Terminals, Or Terminals Pushed Back In The Connector
- STEP 7. Check the wiring harness between the remote controlled mirror (LH) connector E-19 (terminal 1) and junction block connector C-214 (terminal 3).
- Step 8: Check The Heated Door Mirror (RH)
- Step 9: Check The Ground Circuit To The Door Mirror (RH)
- Step 10: Check The Remote Controlled Mirror (RH) Connector E-20 For Loose, Corroded Or Damaged Terminals, Or Terminals Pushed Back In The Connector
- Step 11: Check The Wiring Harness Between The Remote Controlled Mirror (RH) Connector E-20 (Terminal No. 4) And Ground
- Step 12: Check The Remote Controlled Mirror (RH) Connector E-20 For Loose, Corroded Or Damaged Terminals, Or Terminals Pushed Back In The Connector
- Step 13: Check The Wiring Harness Between The Remote Controlled Mirror (RH) Connector E-20 (Terminal No. 1) And Junction Block Connector C-214 (Terminal No. 3)
- Inspection Procedure 1: All Heated Door Mirrors Do Not Operate
- Removal & Installation
- Inspection
- Wiring Diagrams