Lancer, Lancer Evolution VIII & Outlander

Remove the rear seat assembly. Remove the protector. Disconnect the fuel pump module connector. See Fig 1-Fig 3 . After starting the engine and letting it run until it stops naturally, turn the ignition off. Connect the fuel pump module connector. Install the protector and rear seat assembly.

Fig 1: Identifying Fuel Pump Module Connector (Lancer)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 2: Identifying Fuel Pump Module Connector (Lancer Evolution VIII)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 3: Identifying Fuel Pump Module Connector (Outlander)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.