LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2003 >> Lancer Evolution >> Repair and Diagnosis >> General Information >> OBD-II Drive Cycles >> Drive Cycle Procedures >> 2001 Montero >> Pattern 12 >> Test Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test Procedure

  1. Start the engine with all the accessories switched OFF.
  2. Drive the vehicle for 3 minutes at the following conditions. (During the monitor)
    • Vehicle speed: More than 15 km/h (9.4 mph)
    • Engine speed: More than 1,600 r/min, less than 4,000 r/min
    • Engine load: More than 25%, less than 50%
  3. Stop the safe place and let the engine idle for 20 seconds.
  4. Accelerate until the vehicle speed is more than 50 km/h (31 mph).
    • Engine speed: More than 2,500 r/min
    • Engine load: More than 55%
  5. Stop at safe place and let the engine idle for 20 seconds. (During the monitor)

Repeat Steps 4 and 5 for 10 times. Stop the vehicle at the safe place and turn the ignition switch to "LOCK" (OFF) position. Start the engine and do Steps 1 to 7 again. Confirm that the diagnostic trouble code (DTC) is not output.