Test Procedure

1. Start the engine with all accessories switched OFF.
2. Drive the vehicle for 5 minutes at the following conditions. (During the monitor)
   • Engine speed: Less than 3,000 r/min
   • Airflow rate: More than 76 Hz, less than 137 Hz
   • Accelerator pedal: Except full close
   • Without rapid accelerator pedal movement
3. Release the accelerator pedal for 5 seconds.
4. Drive the vehicle for 2 minutes at the following conditions. (During the monitor)
   • Engine speed: Less than 3,000 r/min
   • Airflow rate: More than 76 Hz, less than 137 Hz
   • Accelerator pedal: Except full close
   • Without rapid accelerator pedal movement When the system is normal, the monitor is completed earlier.
5. Stop the safe place and turn the ignition switch to "LOCK" (OFF) position.

Start the engine and do Steps 1 to 5 again. When the vehicle is operating normally and the OBD-II Drive Cycle is carried out, the Readiness Codes will be set as "Complete" on the first drive cycle. The second drive cycle is required to set the Readiness Codes as "Complete" if a fault is detected during the first drive cycle. Confirm that the diagnostic trouble code (DTC) is not output.