LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2003 >> Lancer Evolution >> Repair and Diagnosis >> General Information >> OBD-II Drive Cycles >> Drive Cycle Procedures >> 2001 Montero >> Pattern 5 >> Test Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test Procedure

  1. Start the engine with all the accessories switched OFF.
  2. Drive the vehicle for 16 minutes at the following conditions. (During the monitor)
    • Engine speed: More than 1,600 r/min, less than 4,000 r/min
    • Vehicle speed: More than 30 km/h (18.7 mph)
    • Engine load: More than 26%, less than 50%
    • Without rapid accelerator pedal movement Keep running as long as possible with the power steering pressure switch in the OFF position. When the system is normal, the monitor is completed earlier.
  3. Stop the safe place and turn the ignition switch to "LOCK" (OFF) position.

Start the engine and do Steps 1 to 3 again. When the vehicle is operating normally and the OBD-II Drive Cycle is carried out, the Readiness Codes will be set as "Complete" on the first drive cycle. The second drive cycle is required to set the Readiness Codes as "Complete" if a fault is detected during the first drive cycle. Confirm that the diagnostic trouble code (DTC) is not output.

scientia non olet · About LEMON Manuals