Test Procedure

1. Start the engine with all the accessories switched OFF.
2. Let the engine idle for 30 seconds.
3. Drive the vehicle for 30 seconds at the following conditions. (During the monitor)
   • Engine speed: More than 1,800 r/min, less than 3,500 r/min
   • Engine load: More than 30%, less than 62%
   • Without rapid accelerator pedal movement
4. Stop the safe place and turn the ignition switch to "LOCK" (OFF) position.

Start the engine and do Steps 1 to 4 again. Confirm that the diagnostic trouble code (DTC) is not output.