LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2003 >> Lancer Evolution >> Repair and Diagnosis >> General Information >> OBD-II Drive Cycles >> Drive Cycle Procedures >> 2007 GALANT 2.4L, Outlander >> Pattern 13 >> Test Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test Procedure

  1. Start the engine with all the accessories switched OFF.
  2. Drive the vehicle at 50 km/h (31 mph) for 3 minutes.
  3. Release the accelerator pedal for 5 seconds then stop the safe place.
  4. Accelerate until the vehicle speed is at 50 km/h (31 mph) at the following conditions.
    • Engine speed: More than 1,500 r/min
    • Engine load: More than 40%
  5. Release the accelerator pedal for 5 seconds then stop the safe place.
  6. Repeat Steps 4 and 5 for 2 times.
  7. Stop the safe place and turn the ignition switch to "LOCK" (OFF) position.

Start the engine and do Steps 1 to 7 again. Confirm that the diagnostic trouble code (DTC) is not output.