LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2003 >> Lancer Evolution >> Repair and Diagnosis >> General Information >> OBD-II Drive Cycles >> Drive Cycle Procedures >> 2011-12 OUTLANTER 3.0L >> Pattern 3 >> Test Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test Procedure

  1. Start the engine with all the accessories switched OFF.
  2. Accelerate until the vehicle speed is 60 km/h (38 mph) and then drive the vehicle for 90 seconds.
  3. Release the accelerator pedal and reduce vehicle speed to 30 km/h (18 mph). (During the monitor)
  4. Accelerate until the vehicle speed is 60 km/h (38 mph) and then drive the vehicle for 20 seconds.
  5. Release the accelerator pedal and reduce vehicle speed to 30 km/h (18 mph). (During the monitor)
  6. Stop the safe place and turn the ignition switch to "LOCK" (OFF) position.
  7. Start the engine and do Steps 1 to 6 again. When the vehicle is operating normally and the OBD-II Drive Cycle is carried out, the Readiness Codes will be set as "Complete" on the first drive cycle. The second drive cycle is required to set the Readiness Codes as "Complete" if a fault is detected during the first drive cycle.
  8. Confirm that the diagnostic trouble code (DTC) is not output.
scientia non olet · About LEMON Manuals