LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2003 >> Lancer Evolution >> Repair and Diagnosis >> General Information >> OBD-II Drive Cycles >> Drive Cycle Procedures >> 2011-12 OUTLANTER 3.0L >> Pattern 7 >> Test Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test Procedure

  1. Start the engine with all the accessories switched OFF.
  2. Let the engine idle for 30 seconds. (During the monitor)
  3. Accelerate the vehicle for 2 seconds at the following conditions. (During the monitor)
    • Engine speed: More than 1,500 r/min
    • Engine load: More than 20%
    • Throttle position sensor output voltage: More than 3.5 volts
  4. Stop the safe place and turn the ignition switch to "LOCK" (OFF) position.
  5. Start the engine and do Steps 1 to 4 again.
  6. Confirm that the diagnostic trouble code (DTC) is not output.
scientia non olet · About LEMON Manuals