Auto-Cruise Control System
- General Description
- Special Tools
- Auto-Cruise Control System Diagnosis
- Introduction To Auto-Cruise Control System Diagnosis
- Auto-Cruise Control System Diagnostic Troubleshooting Strategy
- Auto-Cruise Control System Diagnostic Trouble Code Diagnosis
- Diagnostic Result Display Method When Using The Auto-Cruise Control Indicator Light
- Inspection Using Scan Tool MB991502 Data List
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- Symptom Chart
- Symptom Procedures
- INSPECTION PROCEDURE 1: Communication with Scan Tool MB991502 is not Possible (Communication with the Auto-cruise Control-ECU Only is not Possible.)
- INSPECTION PROCEDURE 2: When the Brake Pedal is Depressed, Auto-cruise Control is not Cancelled.
- INSPECTION PROCEDURE 3: When the Selector Lever is Moved to "N" Range, Auto- cruise Control is not Cancelled.
- INSPECTION PROCEDURE 4: When the Auto-cruise Control "CANCEL" Switch is Set to ON, Auto-cruise Control is not Cancelled.
- INSPECTION PROCEDURE 5: Auto-cruise Control cannot be Set.
- INSPECTION PROCEDURE 6: Hunting (Repeated Acceleration and Deceleration) Occurs at the Set Vehicle Speed.
- INSPECTION PROCEDURE 7: Auto-cruise Control Indicator Light Inside Combination Meter does not Illuminate. (However, Auto-cruise Control is Normal.)
- Data List Reference Table
- Check Auto-Cruise Control-Ecu Terminals
- On-Vehicle Service
- Auto-Cruise Control