LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2004 >> Lancer Evolution >> Repair and Diagnosis >> General Information >> OBD-II Drive Cycles >> Drive Cycle Procedures >> 2011-12 OUTLANTER 3.0L >> Pattern 11 >> Test Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test Procedure

  1. Start the engine with all the accessories switched OFF.
  2. Drive the vehicle at 50 km/h (31 mph) for 6 minutes.
  3. Release the accelerator pedal for 10 seconds then stop the safe place. (During the monitor)
  4. Turn the ignition switch to "LOCK" (OFF) position.
  5. Start the engine and do Steps 1 to 4 again. When the vehicle is operating normally and the OBD-II Drive Cycle is carried out, the Readiness Codes will be set as "Complete" on the first drive cycle. The second drive cycle is required to set the Readiness Codes as "Complete" if a fault is detected during the first drive cycle.
  6. Confirm that the diagnostic trouble code (DTC) is not output.
scientia non olet · About LEMON Manuals