Section 44 (Combination Meter)
WARNING: This page is about a different car, the 2017 Mitsubishi Mirage. However, it is still accessible from the selected car via links, so may be relevant.
- Service Specifications
- Special Tools
- Diagnosis
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- DTC B1200: Odometer Failure
- Dtc B1201: Fuel Information Problem
- DTC B1209: Test Mode
- DTC B2463: Rheostat Switch Sticking
- DTC U0100: Engine CAN Timeout
- DTC U0101: T/M CAN Timeout
- DTC U0121: ABS/ASC CAN Timeout
- DTC U0131: EPS CAN Timeout
- DTC U0141: ETACS CAN Timeout
- Diagnosis
- DTC U0151: SRS-ABG CAN Timeout
- DTC U0154: OCM CAN Timeout
- DTC U0168: WCM/F.A.S.T. CAN Timeout
- DTC U1000: OSS/F.A.S.T._OSS CAN Timeout
- DTC U1110: A/C CAN Timeout/Not Equipped
- DTC U1190: No Receive Fault Detect Signal
- DTC U1195: Coding Not Completed
- Trouble Symptom Chart
- Symptom Procedures
- INSPECTION PROCEDURE 1: Power Supply Circuit Check; INSPECTION PROCEDURE 2: The Odometer And The Trip Meter Are Not Displayed.; INSPECTION PROCEDURE 3: No Needle Meters Work.; Inspection Procedure 4: If The Ignition Switch Is Turned To The "ON" Position, The Indicator And Warning Lights Do Not Illuminate Normally
- INSPECTION PROCEDURE 5: The Speedometer Does Not Work (The Other Meters Work)
- INSPECTION PROCEDURE 6: The Tachometer Does Not Work (The Other Meters Work)
- INSPECTION PROCEDURE 7: Tone Alarm Does Not Sound Normally
- Notes
- Technical Description (Comment)
- Notes
- OSS-Related Malfunction Warning Tone Alarm (Vehicles With Kos)
- Engine Switch Reminder Tone Alarm (Vehicles With Kos)
- Ignition Key Reminder Tone Alarm Function (Vehicles Without Kos)
- Light Reminder Tone Alarm
- Door-Ajar Warning Tone Alarm
- Freeze Warning Tone Alarm
- Parking Brake Reminder Tone Alarm
- Multi-Information Display Switch Operation Tone Alarm
- Turn-Signal Light Tone Alarm
- ETACS-Ecu Function Customize Tone Alarm
- A/C Operation Tone Alarm
- Troubleshooting Hints
- Diagnosis
- INSPECTION PROCEDURE 8: Fuel Gauge Does Not Work (The Other Meters Work)
- INSPECTION PROCEDURE 9: The Combination Meter Light Does Not Illuminate Normally Or The Multi-Information Display Is Not Displayed Normally
- INSPECTION PROCEDURE 10: The Multi-Information Display Screen Cannot Be Changed With The Operation Of The Multi-Information Display Switch
- INSPECTION PROCEDURE 11: Parking Brake Reminder Tone Alarm Does Not Sound.; INSPECTION PROCEDURE 12: Brake Warning Light Does Not Illuminate
- INSPECTION PROCEDURE 13: Ambient Temperature Sensor Does Not Work
- INSPECTION PROCEDURE 14: Seat Belt Reminder Function Does Not Work Normally
- INSPECTION PROCEDURE 15: Washer Fluid Level Warning Light Does Not Illuminate.
- Data List
- Actuator Test Table
- Special Function Table
- Check At Combination Meter Terminals
- On-Vehicle Service
- Speedometer Check
- Tachometer Check
- Fuel Level Sensor Check
- Service Reminder Function Set
- Removal And Installation
- Disassembly And Assembly