LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 1990 >> Sentra Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests >> Fuel Control System >> Feedback System
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Feedback System

  1. Start engine and warm to operating temperature. Ensure idle speed and timing are adjusted to specification. Monitor Green LED on ECU while increasing engine speed to about 2000 RPM for 2 minutes under no-load condition.
  2. Note the number of flashes by Green LED every 10 seconds. See ECU GREEN LED FEEDBACK RESPONSE table. Number of flashes during a 10-second period should at least equal number of flashes listed in table.
  3. Race engine 2 or 3 times and allow to idle. Enter self-diagnostic Mode II. Disconnect throttle sensor/switch harness connector. Monitor Red LED and Green LED while idling. Red LED and Green LED should flash simultaneously. If not, adjust airflow meter (if adjustable). See ADJUSTMENTS article.
  4. If airflow meter adjustment does not affect the LEDs, and ECU self-diagnostic system only flashes Code 55 (pass), either airflow meter, oxygen sensor or ECU is defective.
ECU GREEN LED FEEDBACK RESPONSE

Application (1) Flashes (@ 2000 RPM)
Pulsar NX, Sentra 5
(1) Number of flashes in 10-second period.
scientia non olet · About LEMON Manuals