LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 1991 >> Sentra SE-R >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Basic Testing >> Ignition Checks >> Optical (300ZX) >> Ecu Power Transistor Output Signal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Ecu Power Transistor Output Signal

  1. Using a logic probe or DVOM with an analog bar graph function, carefully backprobe 20-pin ECU connector terminals No. 1, 2, 3, 11, 12 and 13 while cranking engine. This tests ECU output signals for triggering the power transistor unit.
  2. If pulse signals of approximately 0.1 volt are available at each specified ECU terminal, replace power transistor unit. If pulse signals are not available at any terminals, go to next step.
  3. Crank engine and check for battery voltage at terminal No. 43 (start signal) of ECU connector. If battery voltage is not present during cranking, repair start signal circuit and retest.
scientia non olet · About LEMON Manuals