LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 1991 >> Sentra SE-R >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Basic Testing >> Ignition Checks >> Optical (300ZX) >> Power Transistor Circuits
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Power Transistor Circuits

  1. Disconnect 7-pin connector from power transistor unit. Disconnect 3-wire ignition coil connector.
  2. Check continuity of each circuit between ignition coil connector terminal "C" and corresponding wire terminal of power transistor unit 7-pin connector. See Figure for ignition coil connector terminal identifications. For wire colors and related ECU connector terminals, see appropriate diagram in WIRING DIAGRAMS article. Repair as necessary.
  3. Disconnect power transistor unit 6-pin connector. Disconnect ECU connector. Check continuity of each wire circuit between power transistor unit and corresponding wire terminal of ECU connector. See appropriate diagram in WIRING DIAGRAMS article.
  4. If continuity does not exist in any of the power transistor 6-pin connector wire terminals, repair open circuit in wires. If there is continuity in all wires but one or more ignition coils is inoperative, reconnect all connectors. Go to ECU POWER TRANSISTOR OUTPUT SIGNAL test below.
scientia non olet · About LEMON Manuals