LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 1997 >> Sentra Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests 1.6 >> Idle Control Systems >> Fast Idle Control Device (FICD) System Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fast Idle Control Device (FICD) System Test

  1. Start engine and warm to operating temperature. Check idle speed. See SPECIFICATIONS article. Adjust idle speed if necessary. See ADJUSTMENTS article. Turn A/C switch and blower fan switch on. Idle speed should increase. If idle speed does not increase, go to next step. If idle speed increases, system is functioning properly.
  2. Ensure A/C compressor functions normally. If compressor is not functioning, repair A/C system as necessary. If compressor is functioning, go to next step.
  3. Turn ignition (engine) off. Disconnect FICD solenoid harness connector. Start engine and let it idle. Measure voltage between ground and FICD harness connector terminal Blue/Red wire. Battery voltage should be present. If battery voltage is present, go to next step. If battery voltage is not present, check 7.5-amp fuse. If fuse is okay, repair open harness or connectors between fuse, A/C relay, and FICD solenoid.
  4. Turn ignition (engine) off. Disconnect FICD solenoid harness connector. Check continuity between ground and FICD solenoid harness connector Black wire. Continuity should exist. If continuity exists, go to next step. If continuity does not exist, repair open Black wire or connectors.
  5. Check FICD solenoid. See FAST IDLE CONTROL DEVICE (FICD) SOLENOID  . If FICD solenoid is okay, check ECM terminals, harness, and connector terminals for pushed-out, damaged, or corroded terminals. Repair or replace as necessary.
scientia non olet · About LEMON Manuals