Fast Idle Control Device (FICD) System Test: Frontier
- Start engine and warm to operating temperature. Check idle speed. See SPECIFICATIONS article. Adjust idle speed if necessary. See ADJUSTMENTS article. Turn A/C switch and blower fan switch on. Idle speed should increase. If idle speed does not increase, go to next step. If idle speed increases, system is functioning properly.
- Ensure A/C compressor functions normally. If compressor is not functioning, repair A/C system as necessary. If compressor is functioning, go to next step.
- Turn ignition off. Disconnect FICD solenoid harness connector. Start engine and let it idle. Measure voltage between ground and FICD harness connector terminal No. 2 (Green/Black wire). Battery voltage should be present. If battery voltage is present, go to next step. If battery voltage is not present, check and repair open or short in Green/Black wire. If wire is okay, check fuse, A/C relay, and FICD solenoid. Repair or replace as necessary.
- Turn ignition off. Check continuity between ground and FICD solenoid harness connector terminal No. 1 (Black/Red wire). Continuity should exist. If continuity exists, go to next step. If continuity does not exist, repair open in Black/Red wire.
- Check FICD solenoid. See FAST IDLE CONTROL DEVICE (FICD) SOLENOID . If FICD solenoid is okay, check PCM terminals and harness connector terminals for pushed-out, damaged, or corroded terminals. Repair or replace as necessary.