Read Configuration Procedure

WARNING: This page is about a different car, the 2004 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carries out CAN communication.

With ignition switch OFF, connect CONSULT-II and CONSULT-II CONVERTER to data link connector and turn ignition switch ON.

Fig 1: Identifying Data Link Connector
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "START (NISSAN BASED VHCL)".

Fig 2: Display Start Nissan Based VHCL
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "BCM" on "SELECT ITEM" screen. If "BCM" is not indicated, go to LAN article to check data link connector (DLC) circuit.

Fig 3: Display Select Item
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "BCM" on "SELECT TEST ITEM" screen.

Fig 4: Display Select Test Item
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "CONFIGURATION" on "SELECT DIAG MODE" screen.

Fig 5: Display Select Diag Mode Screen
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "A34" and "OK" on "VEHICLE SELECT" screen. For canceling, touch "CANCEL" on "VEHICLE SELECT" screen.
NOTE: Confirm vehicle model on IDENTIFICATION PLATE. Refer to MODEL VARIATION in General Information.

Fig 6: Display Vehicle Select
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "READ CONFIGURATION" on "CONFIGURATION" screen.

Fig 7: Display Configuration
Courtesy of NISSAN MOTOR CO., U.S.A.

Configuration of current BCM is printed out automatically. Configuration of brand-new BCM before executing "WRITE CONFIGURATION" is as follows:

SETTING VALUE ITEM

MANUAL SETTING ITEM
Items	Setting Value
DTRL	WITHOUT
AUTO SETTING ITEM
NON ITEM

Fig 8: Consult-II Nissan Read Configuration Display

Courtesy of NISSAN MOTOR CO., U.S.A.

Touch "BACK" on "READ CONFIGURATION" screen.

Fig 9: Display Read Configuration
Courtesy of NISSAN MOTOR CO., U.S.A.