Read Configuration Procedure

WARNING: This page is about a different car, the 2004 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carries out CAN communication.

With ignition switch OFF, connect CONSULT-II and CONSULT-II CONVERTER to data link connector and turn ignition switch ON.

Fig 1: Locating Data Link Connector
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "START (NISSAN BASED VHCL)".

Fig 2: CONSULT-II Display
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "BCM" on "SELECT ITEM" screen. If "BCM" is not indicated, go to General Information Section to check CONSULT II data link connector (DLC) circuit. Refer to CONSULT-II DATA LINK CONNECTOR (PLC) CIRCUIT .

Fig 3: CONSULT-II Display
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "BCM" on "SELECT TEST ITEM" screen.

Fig 4: CONSULT-II Display
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "CONFIGURATION" on "SELECT DIAG MODE" screen.

Fig 5: CONSULT-II Display
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "OTHER" and "OK" on "VEHICLE SELECT" screen. For canceling, touch "CANCEL" on "VEHICLE SELECT" screen.
NOTE: Confirm vehicle model on IDENTIFICATION PLATE. Refer to MODEL VARIATION in GI section.

Fig 6: CONSULT-II Display
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "READ CONFIGURATION" on "CONFIGURATION" screen.

Fig 7: CONSULT-II Display
Courtesy of NISSAN MOTOR CO., U.S.A.
Configuration of current BCM is printed out automatically. Configuration of brand-new BCM before executing "WRITE CONFIGURATION" is as follows.

Fig 8: Brand-New BCM Configuration
Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 9: CONSULT-II Display
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "BACK" on "READ CONFIGURATION" screen.

Fig 10: CONSULT-II Display

Courtesy of NISSAN MOTOR CO., U.S.A.