LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2002 >> Sentra SE-R, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1580 (Body Control System) >> BCM (Body Control Module) >> Configuration >> Read Configuration Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Read Configuration Procedure

WARNING: This page is about a different car, the 2005 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carries out CAN communication.
  1. With ignition switch OFF, connect CONSULT-II and CONSULT-II CONVERTER to data link connector and turn ignition switch ON.
    Fig 1: Locating Data Link Connector
    G03605136Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Touch "START (NISSAN BASED VHCL)".
    Fig 2: CONSULT-II Display - "START (NISSAN BASED VHCL)"
    G03605137Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Touch "BCM" on "SELECT SYSTEM" screen. If "BCM" is not indicated, go to GENERAL INFORMATION to check CONSULT II data link connector (DLC) circuit. Refer to CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT .
    Fig 3: CONSULT-II Display - "BCM" On "SELECT SYSTEM" Screen
    G03605138Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Touch "BCM" on "SELECT TEST ITEM" screen.
    Fig 4: CONSULT-II Display - "BCM" On "SELECT TEST ITEM" Screen
    G03605139Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Touch "CONFIGURATION" on "SELECT DIAG MODE" screen.
    Fig 5: CONSULT-II Display - "CONFIGURATION" On "SELECT DIAG MODE" Screen
    G03605140Courtesy of NISSAN MOTOR CO., U.S.A.
  6. Touch "A60" and "OK" on "VEHICLE SELECT" screen. For canceling, touch "CANCEL" on "VEHICLE SELECT" screen.
    NOTE: Confirm vehicle model on IDENTIFICATION PLATE. Refer to MODEL VARIATION .
    Fig 6: CONSULT-II Display - "A60" & "OK" On "VEHICLE SELECT" Screen
    G03605141Courtesy of NISSAN MOTOR CO., U.S.A.
  7. Touch "READ CONFIGURATION" on "SELECT CONFIG ITEM" screen.
    Fig 7: CONSULT-II Display - "READ CONFIGURATION" On "SELECT CONFIG ITEM" Screen
    G03605142Courtesy of NISSAN MOTOR CO., U.S.A.
  8. Configuration of current BCM is printed out automatically. A listing of manual setting items and auto setting items will be displayed. Auto setting items are preset and cannot be changed. Manual setting items can be set by using WRITE CONFIGURATION PROCEDURE .
    Fig 8: Configuration Of Current BCM Print Out
    G03605143Courtesy of NISSAN MOTOR CO., U.S.A.
  9. Touch "BACK" on "READ CONFIGURATION" screen.
    Fig 9: CONSULT-II Display - "BACK" On "READ CONFIGURATION" Screen
    G03605144Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals