ACC Power Check

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

CHECK ACC POWER
With CONSULT-II

Check key switch "KEY ON SW" in DATA MONITOR mode with CONSULT-II. Refer to DATA MONITOR .

Fig 1: Monitor Item Condition Chart
Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 2: Data Monitor Display
Courtesy of NISSAN MOTOR CO., U.S.A.

Without CONSULT-II

Check voltage between BCM connector M18 terminal 11 and ground.

Fig 3: Connector Terminal Voltage Condition Table
Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 4: Checking Voltage Between BCM Connector M18 Terminal 11 & Ground
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG
1. OK: ACC power circuit is OK.
2. NG: Check the following.
  - 10A fuse [No. 4, located in fuse block (J/B)]
  - Harness for open or short.