| Work support |
This mode enables a technician to adjust some devices faster and more accurate by following the indications on CONSULT-II. |
|
|
- |
- |
- |
- |
| Self-diagnostic results |
Self-diagnostic results can be read and erased quickly. |
|
|
|
|
- |
|
| Trouble diagnostic record |
Current self-diagnostic results and all trouble diagnostic records previously stored can be read. |
- |
- |
- |
|
- |
- |
| ECU discriminated No. |
Classification number of a replacement ECU can be read to prevent an incorrect ECU from being installed. |
- |
- |
- |
|
- |
- |
| Data monitor |
Input/Output data in the ECU (ECM) can be read. |
|
|
|
- |
- |
- |
| DTC work support |
This mode enables a technician to set operating conditions to confirm self-diagnosis status/ results. |
- |
|
- |
- |
- |
- |
| Data monitor (Spec.) |
The specified values will be displayed when an OK/NG judgement is difficult for the DATA MONITOR items by Bar Chart and Line Graph. |
|
- |
- |
- |
- |
- |
| Active test |
Diagnostic Test Mode in which CONSULT-II drives some actuators apart from the ECU (ECM) and also shifts some parameters in a specified range. |
|
- |
|
- |
- |
- |
| ECU (ECM) part number |
ECU (ECM) part number can be read. |
|
|
|
- |
- |
- |
| Control unit initialization |
All registered ignition key IDs in NATS components can be initialized and new IDs can be registered. |
- |
- |
- |
- |
- |
|
| Function test |
Conducted by CONSULT-II instead of a technician to determine whether each system is "OK" or "NG". |
|
- |
- |
|
- |
- |
| SRT & DTC confirmation |
The results of SRT (System Readiness Test) and the self-diagnosis status/results can be confirmed. |
|
- |
- |
- |
- |
- |
| REMO CONT ID SETUP |
A maximum of four IDs (identifications) can be registered in the memory using the remote controller. These IDs can also be confirmed and erased. |
- |
- |
- |
- |
|
- |