BCM (Body Control Module): Consult-II: Notes
WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
CONSULT-II can display each diagnostic item using the following diagnostic test modes: work support, self-diagnosis results, data monitor and active test through data reception and command transmission via the BCM CAN communication lines.
CONTENT DESCRIPTION
| BCM diagnostic test item | Check item, diagnostic test mode | Content |
|---|---|---|
| Inspection by part | Work support | Changes setting of each function. |
| Self-diagnosis results | BCM performs self-diagnosis of CAN communication. | |
| Data monitor | Displays the input data of BCM in real time. | |
| Active test | Gives a drive signal to a load to check the operation. | |
| Configuration | Function to write vehicle configuration on BCM. |