LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 2017 (Body Control System) >> BCM (Body Control Module) >> Configuration >> Read Configuration Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Read Configuration Procedure

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carries out CAN communication.
  1. With ignition switch OFF, connect CONSULT-II and CONSULT-II CONVERTER to data link connector and turn ignition switch ON.
    Fig 1: Connecting CONSULT-II To Data Link Connector
    G04899601
  2. Touch "START (NISSAN BASED VHCL)".
    Fig 2: Identifying CONSULT II Display - START (NISSAN BASED VHCL)
    G04899602
  3. Touch "BCM" on "SELECT SYSTEM" screen.

    If "BCM" is not indicated, go to "CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT ".

    Fig 3: Identifying CONSULT II Display - SELECT SYSTEM
    G04899603
  4. Touch "BCM" on "SELECT TEST ITEM" screen.
    Fig 4: Identifying CONSULT II Display - SELECT TEST ITEM
    G04903945
  5. Touch "CONFIGURATION" on "SELECT DIAG MODE" screen.
    Fig 5: Identifying CONSULT II Display - SELECT DIAG MODE
    G04899604
  6. Touch "R51/D40/N51" and "OK" on "VEHICLE SELECT" screen. For canceling, touch "CANCEL" on "VEHICLE SELECT" screen.
    NOTE: Confirm vehicle model. Refer to "MODEL VARIATION " in GI article.
    Fig 6: Identifying CONSULT II Display - SELECT DIAG MODE
    G04896669
  7. Touch "READ CONFIGURATION" on "SELECT CONFIG ITEM" screen.
    Fig 7: Identifying CONSULT II Display - SELECT CONFIG ITEM
    G04903948
  8. Configuration of current BCM is printed out automatically. A listing of manual setting items and auto setting items will be displayed. Auto setting items are preset and cannot be changed. Manual setting items can be set by using WRITE CONFIGURATION PROCEDURE. Refer to "WRITE CONFIGURATION PROCEDURE ".
    Fig 8: Identifying CONSULT II Display - NISSAN READ CONFIGURATION
    G04903949
  9. Touch "BACK" on "READ CONFIGURATION" screen.
    Fig 9: Identifying CONSULT II Display - READ CONFIGURATION
    G04903950
scientia non olet · About LEMON Manuals