With CONSULT-II

WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

Perform "ACCELERATOR PEDAL RELEASED POSITION LEARNING ".
Perform "THROTTLE VALVE CLOSED POSITION LEARNING ".
Start engine and warm it up to normal operating temperature.
Check that all items listed under the topic PREPARATION (previously mentioned) are in good order.
Select "IDLE AIR VOL LEARN" in "WORK SUPPORT" mode.

Fig 1: CONSULT-II Display - IDLE AIR VOL LEARN
Courtesy of NISSAN NORTH AMERICA, INC.
Touch "START" and wait 20 seconds.

Fig 2: CONSULT-II Display - WORK SUPPORT
Courtesy of NISSAN NORTH AMERICA, INC.
Make sure that "CMPLT" is displayed on CONSULT-II screen. If "CMPLT" is not displayed, Idle Air Volume Learning will not be carried out successfully. In this case, find the cause of the incident by referring to the Diagnostic Procedure below.

Rev up the engine two or three times and make sure that idle speed and ignition timing are within the specifications.

SPEED SPECIFICATIONS

ITEM	SPECIFICATION
Idle speed	675 ± 50 rpm (in P or N position)
Ignition timing	15 ± 5° BTDC (in P or N position)

Fig 3: CONSULT-II Display - WORK SUPPORT

Courtesy of NISSAN NORTH AMERICA, INC.