Diagnostic Procedure

WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

CHECK OVERALL FUNCTION

Check ASCD indicator under the following conditions.

ASCD INDICATOR CONDITIONS

ASCD INDICATOR	CONDITION		SPECIFICATION
CRUISE LAMP	Ignition switch: ON	MAIN switch: Pressed at the 1st time --> at the 2nd time	ON --> OFF
SET LAMP	MAIN switch: ON When vehicle speed is between 40 km/h (25 MPH) and 144 km/h (89 MPH)	ASCD: Operating	ON
SET LAMP		ASCD: Not operating	OFF

OK or NG

OK: INSPECTION END

NG: GO TO 2.

CHECK DTC
Check that DTC U1000 or U1001 is not displayed.

OK or NG

OK: GO TO 3.

NG: Perform trouble diagnoses for DTC U1000, U1001. Refer to "DTC U1000, U1001 CAN COMMUNICATION LINE ".
CHECK COMBINATION METER OPERATION
Does combination meter operate normally?

Yes or No

Yes: GO TO 4.

No: Check combination meter circuit. Refer to "COMBINATION METERS ".
CHECK INTERMITTENT INCIDENT
Refer to "TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT ".

: INSPECTION END