Removal And Installation: Installation

WARNING: This page is about a different car, the 2004 Infiniti M45. However, it is still accessible from the selected car via links, so may be relevant.

Pay attention to the following when installing sensor. Tighten installation bolts and nuts to specified torques.

When installing, make sure that there is no foreign material such as iron chips on pick-up and mounting hole of the sensor. Make sure that no foreign material has been caught in the sensor rotor motor. Remove any foreign material and clean the mount.
When installing front sensor, be sure to press rubber grommets in until they lock at the three locations shown in diagram (2 at shock absorbers and 1 at body panel). When installed, harness must not be twisted. Green line on harness (shaded part) must be visible from front.