Procedure 2 (With Consult-II)

WARNING: This page is about a different car, the 2003 Infiniti M45. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If a electronic key is lost, the ID code of the lost electronic key must be erased to prevent unauthorized use.
When the ID code of a lost electronic key is not known, all controller ID codes should be erased. After all ID codes are erased, the ID codes of all remaining and/or new remote controllers must be re-registered.

Turn ignition switch "OFF".
Connect "CONSULT-II" and "CONSULT-II CONVERTER" to the data link connector.

Fig 1: Locating Data Link Connector
Courtesy of NISSAN MOTOR CO., U.S.A.
Turn ignition switch "ON".
Touch "START (NISSAN BASED VHCL)"

Fig 2: Display Procedure 2 (With Consult-II) START MENU
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "IVMS" If "IVMS" is not indicated, go to "CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT ".

Fig 3: Display Procedure 2 (With Consult-II) - Selecting IVMS
Courtesy of NISSAN MOTOR CO., U.S.A.
Check the model specification, touch either "WITH SUNROOF" or "WITHOUT SUNROOF".
Touch "OK". If the selection is wrong, touch "CANCEL".

Fig 4: Display Select System Sheet With Consult-II - WITH SUNROOF or WITHOUT SUNROOF
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "MULTI-REMOTE CONT SYS".

Fig 5: Display Select System Sheet With Consult-II - MULTI-REMOTE CONT SYS
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "WORK SUPPORT".

Fig 6: Display Select System Sheet With Consult-II - WORK SUPPORT
Courtesy of NISSAN MOTOR CO., U.S.A.
The item shown on the figure at right can be set up.

"REMO CONT ID CONFIR" Use this mode to confirm if a electronic key ID code is registered or not.
"REMO CONT ID REG" Use this mode to register a electronic key ID code.
NOTE: Register the ID code when electronic key or BCM is replaced, or when additional electronic key is required.
"REMO CONT ID ERASUR" Use this mode to erase a electronic key ID code.