Diagnosis Procedure
PROBLEM SYMPTOM TABLE - BOARD COMPUTER
| Symptom | Possible cause | Repair order |
|---|---|---|
| Outside air temperature display is not displayed properly. (It may take a short time to steady the indication after ignition switch is turned ON.)
NOTE:
If the meter is powered up with the ambient sensor disconnected, outside air temperature display will show "&-" even if the sensor is reconnected. In this case, with the sensor connected, disconnect and reconnect the battery, then the correct temperature will be displayed.
|
|
|
| DTE (distance to empty) is not displayed properly.) |
|
|
| Trip distance is not indicated properly. | 1. Vehicle speed sensor signal circuit | 1. Check harness for open or short between combination meter terminal 17 and vehicle speed sensor. |
| Trip time is not indicated properly. | 1. Fuse | 1. 10A fuse [No. 12 (located in fuse block (J/B)]. Verify battery voltage is present at combination meter terminal 13. |
| Average fuel consumption is not displayed properly. | 1. Trip distance display 2. Fuel consumption signal |
1. Check harness for open or short between combination meter terminal 17 and vehicle speed sensor. 2. Check CAN lines for open or short between ECM and combination meter. |
| Average vehicle speed is not indicated properly. | 1. Trip distance display 2. Trip time display |
1. Check harness for open or short between combination meter terminal 17 and vehicle speed sensor. 2. Make sure trip time is displayed properly. If NG, check trip time display. |