General Precautions
WARNING:
When replacing the fuel line parts, observe the following:
- Place a "CAUTION: INFLAMMABLE" sign in the workshop.
- Do not smoke while servicing the fuel system. Keep open flames and sparks away from the work area.
- Have a CO2 fire extinguisher in the workshop.
CAUTION:
- Before removing the fuel line parts, use the following procedures:
- Store the drained fuel in an explosion-proof container and put the lid on securely.
- Release the fuel pressure from the fuel system. Refer to FUEL PRESSURE RELEASE (QG18DE) and FUEL PRESSURE RELEASE (QR25DE).
- Disconnect the battery ground cable.
- Always replace the O-ring seals with new ones.
- Do not kink or twist any of the hoses and tubes during removal and installation.
- Do not over tighten the hose clamps to avoid damaging the hoses.
- After installation, run the engine and check for fuel leaks at the connections.
- Use only a genuine NISSAN fuel filler cap as a replacement. If an incorrect fuel filler cap is used, the MIL may come on.
- For inspection and installation of EVAP system parts, refer to EVAPORATIVE EMISSION SYSTEM (QG18DE) and EVAPORATIVE EMISSION SYSTEM (QR25DE).
- For inspection and installation of ORVR system parts, refer to ON BOARD REFUELING VAPOR RECOVERY (ORVR) (QG18DE) and ON BOARD REFUELING VAPOR RECOVERY (ORVR) (QR25DE).