LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2006 >> Sentra SE-R >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control System >> On Board Diagnostic System Description >> CONSULT-II Inspection Procedure >> Data Monitor Mode
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Data Monitor Mode

DATA MONITOR MODE

MONITOR ITEM CONDITION SPECIFICATION
FR LH SENSOR
FR RH SENSOR
RR LH SENSOR
RR RH SENSOR
Drive vehicle.
(Each wheel is rotating.)
Wheel speed signal
(Almost the same speed as speedometer.)
WARNING LAMP Ignition switch is ON or engine is running. ABS warning lamp is turned on: ON
ABS warning lamp is turned off: OFF
STOP LAMP SW Brake is depressed. Depress the pedal: ON
Release the pedal: OFF
MOTOR RELAY
  1. Drive vehicle at speeds over 30 km/h (19 MPH) for at least 1 minute.
  2. Engine is running.
ABS is not operating: OFF
ABS is operating: ON
ACTUATOR RELAY Ignition switch is ON or engine is running. Ignition switch ON (Engine stops): OFF
Engine running: ON
FR LH OUT SOL
FR LH IN SOL
FR RH OUT SOL
FR RH IN SOL
RR LH OUT SOL
RR LH IN SOL
RR RH OUT SOL
RR RH IN SOL
  1. Drive vehicle at speeds over 30 km/h (19 MPH) for at least 1 minute.
  2. Engine is running.
Operating conditions for each solenoid valve are indicated. ABS is not operating: OFF
BATTERY VOLT Ignition switch is ON or engine is running. Power supply voltage for control unit