Trouble Diagnoses with Battery/Starting/Charging System Tester: Notes

NOTE: To ensure a complete and thorough diagnosis, the battery, starter and generator test segments must be done as a set from start to finish.

Turn off all loads on the vehicle electrical system.
Perform battery test with Battery/Starting/Charging system tester. Refer to "TROUBLE DIAGNOSES WITH BATTERY/STARTING/CHARGING SYSTEM TESTER ".
Press "ENTER" to begin the starting system test.

Fig 1: Tester Display - PRESS ENTER FOR STARTER TEST
Courtesy of NISSAN MOTOR CO., U.S.A.
Start the engine.

Fig 2: Tester Display - START ENGINE
Courtesy of NISSAN MOTOR CO., U.S.A.
Diagnosis result is displayed on the tester. Refer to "DIAGNOSTIC RESULT ITEM CHART ".
NOTE:
- If the starter performs normally but the engine does not start, perform engine diagnosis.
- For intermittent "NO CRANK" or "NO STARTER OPERATION" incidents, refer to "DIAGNOSTIC PROCEDURE 2 ".
Fig 3: Tester Display - CRANKING VOLTAGE
Courtesy of NISSAN MOTOR CO., U.S.A.