Diagnostic Procedure

CHECK OVERALL FUNCTION

Check ASCD indicator under the following conditions.

ASCD INDICATOR CONDITION SPECIFICATION

ASCD INDICATOR	CONDITION		SPECIFICATION
CRUISE LAMP	Ignition switch: ON	MAIN switch: Pressed at 1st time --> 2nd time	ON --> OFF
SET LAMP	MAIN switch: ON When vehicle speed is between 40 km/h (25 MPH) and 144 km/h (89 MPH)	ASCD: Operating	ON
SET LAMP		ASCD: Not operating	OFF

OK or NG

OK: INSPECTION END

NG: GO TO 2.

CHECK DTC
Check that DTC U1000 or U1001 is not displayed.

Yes or No

Yes: Perform trouble diagnoses for DTC U1000, U1001, refer to "DTC U1000, U1001 CAN COMMUNICATION LINE ".

No: GO TO 3.
CHECK COMBINATION METER OPERATION
Does combination meter operate normally?

Yes or No

Yes: GO TO 4.

No: Check combination meter circuit. Refer to "METER/GAUGE OPERATION AND ODO/TRIP METER SEGMENT CHECK IN DIAGNOSIS MODE ".
CHECK INTERMITTENT INCIDENT
Refer to "TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT ".

: INSPECTION END